Solution Skill Assessment- CCNP2 – Download as Word Doc .doc /.docx), PDF. CCNPv6 ROUTE SBA Skills-Based Assessment. SBA CCNP. See more: ccnpv7 switch skills based assessment answers, ccnpv7 route sba answer key, ccnp route v7 final exam answers, ccnpv7 tshoot skills based assessment answers, ccnpv6 route skills-based assessment answers, ccnpv7 route sba. CCNP ROUTE v6: Implementing IP Routing The supported lab list (below) provides a list of CCNP v ROUTE SBA, Skills Based Assessment, CRP.
|Published (Last):||16 October 2017|
|PDF File Size:||15.14 Mb|
|ePub File Size:||7.92 Mb|
|Price:||Free* [*Free Regsitration Required]|
Published on Apr View 4. The public network addresses Configure the routers in the topology according to the diagram and the specifications provided. Test the network for appropriate connectivity and path control.
All contents are Copyright Cisco Systems, Inc. This document is Cisco Public Information. In Part 2, you create a Tcl script to test IPv4 and IPv6 assessmetn and use traceroute and show commands to verify routing and path selection. This exam combines device configuration and troubleshooting. It is not necessary to change the bandwidth or clockrate on the interfaces to reflect a speed difference. To pass the exam, the student is expected to successfully complete the exam in the timeframe allotted.
For the student-training version of the exam, each student has a complete test environment to configure and troubleshoot. Multiple sets of equipment are required, depending on the number of simultaneous exams being conducted. For the Academy student ccnpg6 of this exam, the student is not required to build the topology. You can use other routers such as aor asseasment, and Cisco IOS Software versions if they have comparable capabilities and features.
Depending on the router and Cisco IOS Software version, the commands available and output produced roure vary from what is shown in this lab. Connect all devices as shown in the topology prior to the student beginning the exam.
Use the interfaces specified in the diagram, where possible.
If the exam is being performed on a remote lab pod, such as NetLab, the configuration and interfaces shown should be compatible. Configure the network according to specifications. Configure interfaces with the IP addresses shown in the diagram. Set the bandwidth to kbps on the links between R1, R2, and R3 and set the clock rate on the DCE connections as appropriate.
Add a description for each WAN interface. Configure and test the IPv4 components of the network before configuring the IPv6 components.
CCNPv7 Route Final Skill Exam Preparation
Configure the OSPF router identifier 2. Ensure that all loopback interfaces are advertised in OSPF with the correct masks.
Summarize area 1 to the backbone with the most efficient mask. Configure a static default route from R1 to R2 and avoid a recursive lookup. On R2, filter R1 network Advertise R4s loopback interfaces into BGP. Traffic exiting from R3 and returning to Ccnvp6 should prefer the T1 link.
FAQ: CCNP V »
Add a static route on R4 to Configure the IPv6 loopback and tunnel interfaces on R1 and R3. Test network connectivity and path control. Create a Tcl script and test connectivity from each router to the addresses shown in the diagram.
One or more addresses will not be reachable from all routers after final configuration due to the use asssssment distribute lists to filter routes and the use of IPv4 and IPv6 addressing in the same network. See Tcl script output at end of SBA. Verify that filtered routes are not present in routing tables of the correct routers.
Verify that R4 has a backup route to the AS networks if the T1 link fails. R1 and R3 should also be able to ping the tunnel endpoints. Page 17 of Ccnpv6 Route Lab8 2 Documents. Ccnpv6 Route Lab6 4 Documents.