IEC 62776 PDF

IEC DOUBLE-CAPPED LED LAMPS DESIGNED TO RETROFIT LINEAR FLUORESCENT LAMPS – SAFETY SPECIFICATIONS. IEC , First edition, *) – Double-capped LED lamps Corrigendum, March till IEC är inarbetat i standarden. Buy IEC Ed. Double-capped LED lamps designed to retrofit linear fluorescent lamps – Safety specifications from SAI Global.

Author: Tajinn Voodoogor
Country: Tunisia
Language: English (Spanish)
Genre: Life
Published (Last): 1 June 2011
Pages: 72
PDF File Size: 13.2 Mb
ePub File Size: 6.13 Mb
ISBN: 540-9-15882-274-9
Downloads: 38372
Price: Free* [*Free Regsitration Required]
Uploader: Sazragore

Publication of IEC/EN 62776 – Safety for Double-capped LED Lamps

Opened lamps or inspection of internal component parts of the lamp may be required to verify conformity with Clauses 11, 12 and 14 of this standard. 662776 assessment project in view of the above principles, the standard mainly focuses on the evaluation of: No flashover or breakdown shall occur during the test.

The LED replacement starter 627776 be marked as in Figure 4. NOTE 2 This standard includes photobiological safety. This site uses Akismet to reduce spam.

NOTE 1 The rated voltage or voltage range of the lamp can from the open circuit voltage. The standard is only applicable to LED lamp to meet the following conditions: Recommendations for whole product testing or batch testing are given in Annex A.

  ALASTOR OR THE SPIRIT OF SOLITUDE PDF

In Maygeneral safety requirements IEC If lamps are marked with a voltage range, rated voltage is taken as the maximum of the voltage range marked unless the manufacturer declares another voltage as the most critical one. Figure 8 — Test configuration for touch current measurement.

IEC /ISH – Estonian Centre for Standardisation

C exemption working voltage not exceeding 25Vr. Such LED lamps are designed for replacement without requiring any internal modification of the luminaire.

The length of the lamp not change significantly within the specified ambient temperature range of the lamp. The specific update project 1 based on the above 3 aspects, according to the standard update are: 6277 is then gradually raised to the full value.

Dimension A is measured after the lamp is stabilised and as Aoperating. The publication of this standard gives a suitable safety guide for LED manufacturers exporting to EU market.

Size and gauge requirements: The main contents of update. In cases of doubt regarding the suitability the application the manufacturer of this lamp should be consulted. In the case of doubt based on the inspection of the lamp and the examination of the lamp circuit diagram, and in agreement with the manufacturer or responsible vendor, lamps shall be specially oec so that a fault condition can be simulated and shall be submitted for testing see Clause Following IECSection 8, basic insulation during lamp insertion is sufficient.

  LJUBISA PAVKOVIC KOLA PDF

The content of the instructions shall include the following. Further requirements on failing safe are given in Clause Variation of dimension A due 6.

Example for a retrofit ie. Figure 7 — Schematic steps of removing a fluorescent lamp and inserting a double-capped LED ied designed to retrofit linear fluorescent lamp 5.

IEC /ISH | IEC Webstore

Labeling requirements are to power ballast lamps? Intertek is a leading Total Quality Assurance provider to industries worldwide. The marking shall be legible after the test. The lamp under test shall consist of a iecc unit, operated at its rated supply voltage.

Safety requirements under the new standard IEC 62776

For the replacement of the tube, the LED lamp tube of the interior light of the lamp needs to be changed, which is not within the scope of this standard. The requirements in this standard are given for general lighting service excluding for example explosive atmospheres.

Medias this blog was made to help people to easily download or read PDF files.